Motor Controllers

HL-M2008B

An electronic parking-brake controller for new-energy, commercial and construction vehicles.

HL-M2008B product image

Key parameters

Voltage

12 V

Peak current

—

Protection

IP65

Temperature

-40 – 85 ℃

Supported motor types

Brushed DC parking-brake motors

Communication / I/O

Dual EPB motor drive, 4 wheel-speed inputs, hard-wired + CAN control

Model matrix

ModelVoltagePeak currentRated current
HL-M2008B12 V——

Features

  • Power-stage and thermal design for equipment integration.
  • Control functions selected around the motor, feedback device and duty cycle.
  • CAN and I/O configuration confirmed against the vehicle or equipment interface.

Typical application directions: New-energy vehicles, Commercial vehicles, Electronic parking-brake systems

Connectors & pin definitions

Dual EPB motor drive, 4 wheel-speed inputs, hard-wired + CAN control

Control / motor connector

Control / motor connector

Purpose
Control / motor connector
Applicable models
HL-M2008B
PinSignalFunctionElectrical parameters / notes
1NC\
2DIinput, Configurable active-high / active-low level
3NC\
4NC\
5BLS1
6AIinput, Configurable current / voltage type; voltage type by default
7AIinput, Configurable current / voltage type; voltage type by default
8DOEPB indicator, (3A)Low-side output
9DOParking brake release signal, (3A)Low-side output
10DIParking brake release signal, Configurable high / low level
11DO(3A)Low-side output , Reserved
12Right motor terminal
13VSupply positive, 12V
14Left motor terminal
15VSupply positive, 12V
16CAN-HCAN-H signal
17CAN-LCAN-L signal
18DIParking brake apply signal, Configurable high / low level
19DOParking brake apply signal, (3A)Low-side output
20BLS2
21BOOTModule enable signal, active-high
22Front-left wheel speed signal
23Front-right wheel speed signal
24Rear-left wheel speed signal
25Rear-right wheel speed signal
26DO(3A)Low-side output , Reserved
27Right motor terminal 2
28V-Supply negative
29Left motor terminal 2
30V-Supply negative

Source: product catalog, series starts on page 28

Wiring

  • Parking brake apply / release is controlled through hard-wired signals or CAN.

    Applicable models: HL-M2008B · Catalog series starts on page 28
  • Digital input / output active-high / active-low levels are configurable.

    Applicable models: HL-M2008B · Catalog series starts on page 28
  • Analog inputs are configurable for current or voltage types to suit different sensor interfaces.

    Applicable models: HL-M2008B · Catalog series starts on page 28

Documents

Use the full catalog for offline reference and archiving.

Start a conversation

Confirm the match against the equipment duty cycle

Vehicle and actuator conditions differ. Confirm the selection range against the actual project requirements.

Contact us