Intelligent Power Distribution

HL-C2006A

A solid-state relay module for monitored and protected high-current output in 24 V equipment electrical systems.

HL-C2006A product image

Key parameters

Voltage

24 V

Peak current

2800 A

Protection

IP65

Temperature

-40 – 85 ℃

Communication / I/O

Single-channel high-power solid-state relay, rated 300 A / peak 2800 A (15 s), 1 DI + CAN

Dimensions

169 × 76 × 57 mm

Model matrix

ModelVoltagePeak currentRated current
HL-C2006A24 V2800 A 15 s300 A

Features

  • Output channels and protection functions are defined by the selected model.
  • Load monitoring and diagnostic functions support equipment integration.
  • CAN and I/O connections are matched to the vehicle electrical architecture.

Typical application directions: Application suitability is confirmed against the selected model and project requirements.

Connectors & pin definitions

Single-channel high-power solid-state relay, rated 300 A / peak 2800 A (15 s), 1 DI + CAN

CAN / enable connector · AT04-6P; V+OUT terminal stud · M6; V+IN terminal stud · M6; GND terminal stud · M6

CAN / enable connector

Purpose
CAN / enable connector
Connector / terminal
AT04-6P
Applicable models
HL-C2006A
PinSignalFunctionElectrical parameters / notes
1CAN_HCAN high
2CAN_LCAN low
3NULLUnused
4EnableHard-wired enable
5GNDGround
624V_Out24V output (maximum 5m A)

Source: product catalog, series starts on page 42

V+OUT terminal stud

Purpose
V+OUT terminal stud
Connector / terminal
M6
Applicable models
HL-C2006A
PinSignalFunctionElectrical parameters / notes
V+OUTV+OUTDigital output DO/PWM

Source: product catalog, series starts on page 42

V+IN terminal stud

Purpose
V+IN terminal stud
Connector / terminal
M6
Applicable models
HL-C2006A
PinSignalFunctionElectrical parameters / notes
V+INV+INBattery positive

Source: product catalog, series starts on page 42

GND terminal stud

Purpose
GND terminal stud
Connector / terminal
M6
Applicable models
HL-C2006A
PinSignalFunctionElectrical parameters / notes
GNDGNDBattery negative

Source: product catalog, series starts on page 42

Wiring

  • Connect load negative and battery negative together. Enable is active-high: add a switch between pins 4 and 6.

    Applicable models: HL-C2006A · Catalog series starts on page 42
  • PWM frequency up to 1Mhz.

    Applicable models: HL-C2006A · Catalog series starts on page 42
  • 1 digital input with configurable input signal.

    Applicable models: HL-C2006A · Catalog series starts on page 42

Dimensions & mounting

  • Overall dimensions: Length 169, Width 76, Height 57

    Applicable models: HL-C2006A · Catalog series starts on page 42

Diagnostics & notes

  • Current sensing with load open-circuit / short-circuit protection.

    Applicable models: HL-C2006A · Catalog series starts on page 42
  • Hard-wired control (CAN takes priority).

    Applicable models: HL-C2006A · Catalog series starts on page 42

Documents

Use the full catalog for offline reference and archiving.

Start a conversation

Confirm the match against the equipment duty cycle

Vehicle and actuator conditions differ. Confirm the selection range against the actual project requirements.

Contact us